Someday this page will expand and branch much more comprehensively than it does now. But for now I want to describe the most important (and inobvious) to set up.
These are all text documents.
It's really, really important to get this one right. All controllers fresh from the factory are set up as Mark IV presses. You want to set your Press Model (Commander, Pro-Glide, MSP, Mark III) right away.
For the Station to show up on the Host (Master) computer, you must set the Station Number correctly.
OK, this one only applies if your machine has something other than eighth inch gearing, including dual gearing. This is the procedure to view or change the number of gear teeth that the Registration System thinks are on the Impression Cylinder Print Roll Drive Gear:
M. L. Riechers Systems Engineering Voice: +1-513-844-2220 530 Main Street Fax: +1-513-844-2279 Hamilton, Ohio 45013-3222, USA mlr(at)rse(dot)com
The Webmaster of this site is free to use the images below on an Apache/NetBSD-powered Web server. Thanks for using Apache on NetBSD!